This was my prototype and selling it for $50.
A few things bugged me with the Prem table that had me create this.
1. That yellow warning label in the middle. Once someone mentioned it that is all I could see. Kinda like those warnings on your car visor.
2. There is a hole that can fit the QR reader on the bottom right. Seems silly to remove a lit plastic to install that QR Reader on the upper part.
3. Instruction cards are held in by their corners. At least the pro aprons have it recessed.
Pretty sure this wont fit a Pro but don't have one to compare.
I use a 2sided 3M adhesive to mount it. It is thin and similar to what they use to mount Credit cards when mailed. It comes off nicely and didn't damage my artwork beneath it.
NOTE ABOUT THE CONNECT RELOCATION! \Even though Stern has a square hole and two posts. The QR reader will fit but sits crooked. If you are OCD you may want to mod the QR reader. I drilled the holes on the reader out but warn that is not an easy thing to do.
If you dont have connect I can print a plug for the hole in the mod.
You can use your own score cards and will fit with the same spacing. I can also print you some card if you dont like the ones I used. (I liked the artwork I found for the QR Card)
You can browse the Stranger Things cards found under the forum title "Custom Apron Cards - (Printable Versions Only)"
A few things bugged me with the Prem table that had me create this.
1. That yellow warning label in the middle. Once someone mentioned it that is all I could see. Kinda like those warnings on your car visor.
2. There is a hole that can fit the QR reader on the bottom right. Seems silly to remove a lit plastic to install that QR Reader on the upper part.
3. Instruction cards are held in by their corners. At least the pro aprons have it recessed.
Pretty sure this wont fit a Pro but don't have one to compare.
I use a 2sided 3M adhesive to mount it. It is thin and similar to what they use to mount Credit cards when mailed. It comes off nicely and didn't damage my artwork beneath it.
NOTE ABOUT THE CONNECT RELOCATION! \Even though Stern has a square hole and two posts. The QR reader will fit but sits crooked. If you are OCD you may want to mod the QR reader. I drilled the holes on the reader out but warn that is not an easy thing to do.
If you dont have connect I can print a plug for the hole in the mod.
You can use your own score cards and will fit with the same spacing. I can also print you some card if you dont like the ones I used. (I liked the artwork I found for the QR Card)
You can browse the Stranger Things cards found under the forum title "Custom Apron Cards - (Printable Versions Only)"
Attachments
Last edited:
