Currently working on a friends Earthshaker and I am encountering a bit of a weird one:
All 3 pop bumpers will not fire and the shaker motor is lifeless.
I thought for sure, this is a fuse/ getting power to the coils issue. They are all connected to the +25V special solenoid circuit on the Aux. driver Board.
Turns out there is 37-38V at each coil. So I thought, no problem, I will short the other side of the solenoid lug to a ground cable to verify it fires and chase the ground/cpu side of things. Turns out, when I ground the coils, nothing happens!
Four questions:
1) WTF? Does this mean all 3 coils have shorted? I have not seen this before. Everything has the correct fuse values.
2) I'm supposed to have +25V at the coils. Instead I have + 37V. I checked and I have +37V off the transformer. Is it possible that the transformer has shorted and also cooked all 3 coils? Will the transformer being off-spec be enough to cause damage? Do I need a new transformer, everything else works fine?
3) If 2 is true, why the hell are the fuses not popping? There a no less than 3 fuses prior to the jet bumpers (two on the boards in series and one under the playfeild)
4) Am I grounding coils wrong? If I have +37V on the Red-White lug, I should be able to connect the Blue lug straight to ground to get the coil fire right? (take the CPU out of the mix).
I'm sure I'll figure it out and I don't doubt I am missing something. Just thought I would put it out in the universe to see if I am missing something obvious. I am used to WPC, this is my first system 11, so maybe things work different.
**Just re-reading this, I realized I did not meter out the jumper cable, so that could be the problem** I will try again tonight.
Thanks in advance.
All 3 pop bumpers will not fire and the shaker motor is lifeless.
I thought for sure, this is a fuse/ getting power to the coils issue. They are all connected to the +25V special solenoid circuit on the Aux. driver Board.
Turns out there is 37-38V at each coil. So I thought, no problem, I will short the other side of the solenoid lug to a ground cable to verify it fires and chase the ground/cpu side of things. Turns out, when I ground the coils, nothing happens!
Four questions:
1) WTF? Does this mean all 3 coils have shorted? I have not seen this before. Everything has the correct fuse values.
2) I'm supposed to have +25V at the coils. Instead I have + 37V. I checked and I have +37V off the transformer. Is it possible that the transformer has shorted and also cooked all 3 coils? Will the transformer being off-spec be enough to cause damage? Do I need a new transformer, everything else works fine?
3) If 2 is true, why the hell are the fuses not popping? There a no less than 3 fuses prior to the jet bumpers (two on the boards in series and one under the playfeild)
4) Am I grounding coils wrong? If I have +37V on the Red-White lug, I should be able to connect the Blue lug straight to ground to get the coil fire right? (take the CPU out of the mix).
I'm sure I'll figure it out and I don't doubt I am missing something. Just thought I would put it out in the universe to see if I am missing something obvious. I am used to WPC, this is my first system 11, so maybe things work different.
**Just re-reading this, I realized I did not meter out the jumper cable, so that could be the problem** I will try again tonight.
Thanks in advance.